The diameter value used to identify a ball size.
The distance between two parallel planes tangent to the surface of a ball.
The arithmetic mean of the largest and the smallest actual single diameters, Dws of a ball.
The difference between the largest and the smallest actual single diameters, Dws of one ball
The greatest radial distance in any radial plane between a sphere circumscribed around the ball surface and any point on the ball surface.
For the purposes of this standard, a lot is a definite quantity of balls manufactured under conditions which are presumed uniform, and which is considered an entity.
The arithmetic mean of the mean diameter of the largest ball and that of the smallest ball, Dwm in a lot
The difference between the mean diameter of the largest ball and that of the smallest ball, Dwm, in a lot. This definition only applies to ball grades G 3 to G 200.
Range within which Dwml may vary for a particular ball gage. The amount St is equal to the ball gage interval, Ig.
The difference between the largest and the smallest mean gage diameters, Dwm established for a particular gage.
One of the intervals into which the deviation of the nominal diameter of a ball is divided.
The amount by which a mean ball diameter of a lot (for Vdwl), or a subset of a lot (for Vdwa), differs from the nominal ball diameter, Dw, rounded to a whole multiple of the ball gage interval, Ig.
The difference between the lot mean diameter, DwmL, and the sum of the nominal diameter, Dw and the ball gage, S, i.e. ΔS=Dwml-(Dw+S)
Measure of resistance to penetration as determined by specific methods.
青岛百克滚珠传动部件有限公司
Qingdao BRBC Balls & Transmission Parts Co., Ltd.
921 Tuanjie Road
Economic and Technological Development Zone
Qingdao, Shandong Province
Tel: (+86-532) 8610 7680
Fax: (+86-532) 8610 7682
Email: contact@brbc.cn